Cisco CCNP / BSCI Tutorial: Comparing OSPF and ISIS Hellos
By Chris Bryant
While studying to pass the BSCI exam and preparing to earn your CCNP certification, you'll quickly notice that while OSPF and ISIS are both link-state protocols, there are a lot of differences between the two. One major difference is the way the two protocols handle hello packets.
Hello packets are imperative to keeping OSPF and ISIS adjacencies alive. Since they are both link-state protocols, neither of them will send updates at any specified time. Hello packets are the only method by which routers running OSPF and ISIS can see that a neighboring router is still available.
OSPF gives us some great options when it comes to keeping routing table size down via the use of stub and total stub areas, but to OSPF, a hello packet is a hello packet. ISIS routers are capable of sending two different types of hellos - Level 1 and Level 2.
ISIS routers are classified as Level 1 (L1), Level 2 (L2), and Level 1-2 (L1-L2). By default, Cisco routers are L1-L2 routers; this means that every ISIS-enabled interface will send out both L1 and L2 hellos.
If one of the interfaces is forming only an L1 or L2 adjacency, there's no reason to send out hellos for the other adjacency type. For example, if R1 is forming an L1 adjacency with R2 via its ethernet0 interface, there is no reason to allow the router to transmit L2 hellos. To hardcode a router interface to send only L1 or L2 hellos, use the isis circuit-type command.
R1(config)#interface ethernet0
R1(config-if)#isis circuit-type level-1
Note: To configure this interface to send only L2 hellos, the full command is "isis circuit-type level-2-only", not just "level-2".
This configuration would prevent L2 hellos from being transmitted out ethernet0. While this does save router resources and prevents unnecessary bandwidth usage, there is also no way an L2 adjacency can be formed - so double-check your network topology before using this command!
About the author
Chris Bryant, CCIE #12933, is the owner of The Bryant Advantage , home of free CCNA and CCNP tutorials! Pass the BSCI exam with Chris Bryant! from http://www.FreeArticlesAndContent.com
|
|
Copy This Article
For FREE!!!
You can use this article and copy it on your own website
for free! All you have to do is make sure the article
is copied with no changes and includes the "About
The Author" text. Also please ensure that all url's
are hyperlinked according. Thank you. |
Link To This Article - And We'll
Link Back To Your Website!
You are more then welcome to link to this article! All
you have to do is copy this webpage address from the
address bar and create a link on your website. Please
use the title of this article for your link text. Please
get in contact once you have linked to this article
and we'll link back to you! Thank you. |
|
|
|
Other great articles from this category...
|
Related Sites
|
|
